Table of Contents
Advertisement
----------------Security----------------------------------
SSID Broadcast
Multicast cipher
Unicast cipher
WPA clients
Encryption
Default Transmit Key
Static Keys :
Key 1: *****
Authentication Type
==========================================================
SMC-AP#
Note: The index and length values used in the key command must be
the same values used in the encryption and transmit-key
commands.
CLI Commands for WEP over 802.1x Security – From the
802.11g interface configuration mode, use the authentication
command to select open system authentication. Use the
multicast-cipher command to select WEP cipher type. Then set
802.1x to required with 802.1x command, and disable MAC
authentication with the mac-authentication command. To view
the current 802.11g security settings, use the show interface
wireless g command (not shown in example).
SMC-AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
SMC-AP(if-wireless g)#authentication open
SMC-AP(if-wireless g)#encryption 128
SMC-AP(if-wireless g)#multicast-cipher wep
SMC-AP(if-wireless g)#end
SMC-AP(config)#802.1x required
SMC-AP(config)#no mac-authentication
SMC-AP(config)#
: DISABLED
: TKIP
: WEP
: SUPPORTED
: 128-BIT ENCRYPTION
: 1
Key 2: EMPTY
: SHARED
Radio Interface
Key 3: EMPTY
Key 4: EMPTY
6-68
6-82
6-83
6-88
6-51
6-57
5-53
Advertisement
Table of Contents
