Table of Contents
Advertisement
Command Line Interface
To enter the Global Configuration mode, enter the command
configure in Exec mode. The system prompt will change to
"SMC Enterprise AP(config)#" which gives you access privilege
to all Global Configuration commands.
SMC-AP#configure
Enter Ethernet configuration commands, one per line.
SMC-AP(config)#
To enter Interface mode, you must enter the "interface ethernet,"
or "interface wireless g" command while in Global Configuration
mode. The system prompt will change to "SMC Enterprise
AP(if-ethernet)#," or SMC Enterprise AP(if-wireless)" indicating
that you have access privileges to the associated commands. You
can use the end command to return to the Exec mode.
SMC-AP(config)#interface ethernet
SMC-AP(if-ethernet)#
Command Line Processing
Commands are not case sensitive. You can abbreviate
commands and parameters as long as they contain enough
letters to differentiate them from any other currently available
commands or parameters. You can use the Tab key to complete
partial commands, or enter a partial command followed by the "?"
character to display a list of possible matches. You can also use
the following editing keystrokes for command-line processing:
Keystroke
Ctrl-A
Ctrl-B
Ctrl-C
Ctrl-E
Ctrl-F
Ctrl-K
Ctrl-L
6-8
Function
Shifts cursor to start of command line.
Shifts cursor to the left one character.
Terminates a task and displays the command prompt.
Shifts cursor to end of command line.
Shifts cursor to the right one character.
Deletes from cursor to the end of the command line.
Repeats current command line on a new line.
Advertisement
Table of Contents
