SMC Networks 2552W-G User Manual page 52

Initial Configuration
IP Configuration – Either enable or disable (Dynamic Host
3.
Configuration Protocol (DHCP) for automatic IP configuration.
If you disable DHCP, then manually enter the IP address and
subnet mask. If a management station exists on another
network segment, then you must enter the IP address for a
gateway that can route traffic between these segments. Then
enter the IP address for the primary and secondary Domain
Name Servers (DNS) servers to be used for host-name to IP
address resolution.
DHCP Client – With DHCP Client enabled, the IP address,
subnet mask and default gateway can be dynamically
assigned to the access point by the network DHCP server.
(Default: Enable)
Note: If there is no DHCP server on your network, then the access
4-8
point will automatically start up with its default IP address,
192.168.2.2.