Table of Contents
Advertisement
CLI Commands for the 802.11g Wireless Interface – From the
global configuration mode, enter the interface wireless g
command to access the 802.11g radio interface. Set the interface
SSID using the ssid command and, if required, configure a name
for the interface using the description command. You can also
use the no ssid-broadcast command to stop sending the SSID
in beacon messages. Select a radio channel or set selection to
Auto using the channel command. Set any other parameters as
required. To view the current 802.11g radio settings, use the
show interface wireless g command.
SMC-AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
SMC-AP(if-wireless g)#description RD-AP#3
SMC-AP(if-wireless g)#ssid r&d
SMC-AP(if-wireless g)#channel auto
SMC-AP(if-wireless g)#ssid-broadcast
SMC-AP(if-wireless g)#select-antenna-mode right antenna
SMC-AP(if-wireless g)#radio-mode g
SMC-AP(if-wireless g)#transmit-power full
SMC-AP(if-wireless g)#speed 6
SMC-AP(if-wireless g)#max-association 32
SMC-AP(if-wireless g)#beacon-interval 150
SMC-AP(if-wireless g)#dtim-period 5
SMC-AP(if-wireless g)#fragmentation-length 512
SMC-AP(if-wireless g)#rts-threshold 256
SMC-AP(if-wireless g)#exit
Radio Interface
6-68
6-75
6-78
6-77
6-75
6-74
6-73
6-86
6-76
6-87
6-78
6-79
6-80
6-81
5-45
Advertisement
Table of Contents
