Bridge Add/Edit - ZyXEL Communications ZYWALL USG 2000 Manual

Unified security gateway

Hide thumbs Also See for ZYWALL USG 2000:

Table of Contents

Table 63 Network > Interface > Bridge (continued)

10.10.4 Bridge Add/Edit

This screen lets you configure IP address assignment, interface bandwidth

parameters, DHCP settings, and ping check for each bridge interface. To access

this screen, click the Add icon at the top of the Add column in the Bridge

Summary screen, or click an Edit icon in the Bridge Summary screen. The

following screen appears.

ZyWALL USG 2000 User's Guide

This column lets you create, edit, remove, activate, and deactivate

To create a bridge interface, click the Add icon at the top of the

column. The Bridge Add/Edit screen appears.

To create a virtual interface, click the Add icon next to the

corresponding bridge interface. The Virtual Interface Add/Edit

screen appears. See

Section 10.12 on page

To edit an interface, click the Edit icon next to it. The Bridge Add/

Edit screen or Virtual Interface Add/Edit screen appears

accordingly.

To remove an interface, click the Remove icon next to it. The ZyWALL

confirms you want to remove it before doing so.

To activate or deactivate an interface, click the Active icon next to it.

Make sure you click Apply to save and apply the change.

Click Apply to save your changes back to the ZyWALL.

Click Reset to begin configuring this screen afresh.

Chapter 10 Interface