Configuring Adp Policies - ZyXEL Communications ZYWALL USG 2000 Manual

Chapter 31 ADP
Table 155 Anti-X > ADP > General (continued)
LABEL
Add icon
Apply
Reset

31.2.1 Configuring ADP Policies

Click Anti-X > ADP > General and then an Add or Edit icon to display the
following screen. Use this screen to apply an ADP profile to a traffic direction.
Figure 363 Anti-X > ADP > General > Add
526
DESCRIPTION
Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the entry is enabled or not. Click it
to activate or deactivate the entry. Make sure you click Apply to
save and apply the change.
Click the Edit icon to go to the screen where you can edit the entry.
Click the Add icon in an entry to add an entry below the current
entry.
Click the Remove icon to delete an existing entry from the ZyWALL.
A window displays asking you to confirm that you want to delete the
entry. Note that subsequent entries move up by one when you take
this action.
In a numbered list, click the Move to N icon to display a field to type
an index number for where you want to put that entry and press
[ENTER] to move the entry to the number that you typed. For
example, if you type 6, the entry you are moving becomes number 6
and the previous entry 6 (if there is one) gets pushed up (or down)
one.
The ordering of your entries is important as they are applied in order
of their numbering.
Click Apply to save your changes.
Click Reset to start configuring this screen again.
ZyWALL USG 2000 User's Guide