Interface; Trunks - ZyXEL Communications ZYWALL USG 2000 Manual

Chapter 5 Configuration Basics
WHERE USED
Example: This provides a simple example to show you how to configure this
feature. The example is usually based on the network topology in
page 103.
Note: PREQUISITES or WHERE USED does not appear if there are no prerequisites
or references in other features to this one. For example, no other features
reference DDNS entries, so there is no WHERE USED entry.

5.4.2 Interface

See Section 5.2 on page 102
Note: When you create an interface, there is no security applied on it until you assign
it to a zone.
Most of the features that use interfaces support Ethernet, PPPoE/PPTP, VLAN, and
bridge interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: Interface ge1 is in the LAN zone and uses a private IP address. To
configure ge1's settings, click Network > Interface > Ethernet and then ge1's
Edit icon.

5.4.3 Trunks

Use trunks to set up load balancing using two or more interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: See
106
There are two uses for this.
These are other features you should usually configure or check right
after you configure the main screen(s) for this feature. For example,
you should usually create a policy route for a VPN tunnel.
You have to delete the references to this feature before you can delete
any settings. For example, you have to delete (or modify) all the
policy routes that refer to a VPN tunnel before you can delete the VPN
tunnel.
for background information.
Network > Interface (except Network > Interface > Trunk)
Port groups (configured in the Interface > Port Grouping screen)
Zones, trunks, IPSec VPN, device HA, DDNS, policy routes, static
routes, HTTP redirect, virtual server, application patrol
Network > Interface > Trunk
Interfaces
Policy routes
Chapter 6 on page 119.
Figure 50 on
ZyWALL USG 2000 User's Guide