The Session Limit Edit Screen - ZyXEL Communications ZYWALL USG 2000 Manual

Chapter 20 Firewall

20.3.1 The Session Limit Edit Screen

Click Firewall > Session Limit and the Add or Edit icon to display the Firewall
Session Limit Edit screen. Use this screen to configure rules that define a
session limit for specific users or addresses.
Figure 215
The following table describes the labels in this screen.
Table 105 Firewall > Session Limit > Edit
LABEL
Enable Rule
Description
User
Address
Session Limit
per Host
OK
Cancel
336
Firewall > Session Limit > Edit
DESCRIPTION
Select this check box to turn on this session limit rule.
Enter information to help you identify this rule. Use up to 64 printable
ASCII characters. Spaces are allowed.
Select a user name or user group to which to apply the rule. Select
Create Object to configure a new user account (see
page 613 for details). The rule is activated only when the specified user
logs into the system and the rule will be disabled when the user logs
out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies.
Select Create Object to configure a new one. Select any if the policy is
effective for every source address.
Use this field to set a limit to the number of concurrent NAT/firewall
sessions this rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default
Session per Host setting in the general Firewall Session Limit
screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Chapter 36 on
ZyWALL USG 2000 User's Guide