Cellular Status Screen - ZyXEL Communications ZYWALL USG 2000 Manual

Unified security gateway

Hide thumbs Also See for ZYWALL USG 2000:

Table of Contents

Chapter 10 Interface

Table 56 Interface > Cellular > Add (continued)

Device Settings

Band Selection This field appears if you selected a 3G device that allows you to select

10.8 Cellular Status Screen

To check your 3G connection status, click Network > Interface > Cellular >

Status. The following screen displays.

Figure 138 Interface > Cellular > Status

Enter the priority of the gateway (if any) on this interface. The

ZyWALL decides which gateway to use based on this priority. The

lower the number, the higher the priority. If two or more gateways

have the same priority, the ZyWALL uses the one that was configured

Select the 3G card to use with this entry or select auto to have the

ZyWALL automatically detect the type of card.

the type of network to use. Select the type of 3G service for your 3G

connection. If you are unsure what to select, check with your 3G

service provider to find the 3G service available to you in your region.

Select auto to have the card connect to an available network. Choose

this option if you do not know what networks are available.

You may want to manually specify the type of network to use if you

are charged differently for different types of network or you only have

one type of network available to you.

Select GPRS / EDGE (GSM) only to have this interface only use a

2.5G or 2.75G network (respectively). If you only have a GSM

network available to you, you may want to select this so the ZyWALL

does not spend time looking for a WCDMA network.

Select UMTS / HSDPA (WCDMA) only to have this interface only

use a 3G or 3.5G network (respectively). You may want to do this if

you want to make sure the interface does not use the GSM network.

Click OK to save your changes back to the ZyWALL.

Click Cancel to exit this screen without saving.

ZyWALL USG 2000 User's Guide