ZyXEL Communications ZYWALL USG 2000 Manual page 196

Chapter 10 Interface
Table 50 Network > Interface > Ethernet > Edit (continued)
LABEL
Lease time
Enable IP/MAC
Binding
Enable Logs
for IP/MAC
Binding
Violation
Edit static
DHCP table
Related Setting
Configure
PPPoE/PPTP
Configure
VLAN
Configure
WAN TRUNK
Configure
Policy Route
More Settings/
Less Settings
RIP Setting
Enable RIP
Direction
Send Version
Receive
Version
V2-Broadcast
OSPF Setting
196
DESCRIPTION
Specify how long each computer can use the information (especially
the IP address) before it has to request the information again.
Choices are:
infinite - select this if IP addresses never expire.
days, hours, and minutes - select this to enter how long IP
addresses are valid.
Select this option to have this interface enforce links between specific
IP addresses and specific MAC addresses. This stops anyone else from
manually using a bound IP address on another device connected to
this interface. Use this to make use only the intended users get to use
specific IP addresses.
Select this option to have the ZyWALL generate a log if a device
connected to this interface attempts to use an IP address that is
bound to another device's MAC address.
Click this to configure static IP addresses for the ZyWALL to assign to
computers connected to this interface. See
Click PPPoE/PPTP if this interface's Internet connection uses PPPoE
or PPTP.
Click VLAN if you want to configure a VLAN interface for this Ethernet
interface.
Click WAN TRUNK to go to a screen where you can set this interface
to be part of a WAN trunk for load balancing.
Click Policy Route to go to the screen where you can manually
configure a policy route to associate traffic with this interface.
Click this button to display a greater or lesser number of configuration
fields.
See Section 13.2 on page 264
Select this to enable RIP in this interface.
This field is effective when RIP is enabled. Select the RIP direction
from the drop-down list box.
BiDir - This interface sends and receives routing information.
In-Only - This interface receives routing information.
Out-Only - This interface sends routing information.
This field is effective when RIP is enabled. Select the RIP version(s)
used for sending RIP packets. Choices are 1, 2, and 1 and 2.
This field is effective when RIP is enabled. Select the RIP version(s)
used for receiving RIP packets. Choices are 1, 2, and 1 and 2.
This field is effective when RIP is enabled. Select this to send RIP-2
packets using subnet broadcasting; otherwise, the ZyWALL uses
multicasting.
See Section 13.3 on page 265
Section 10.5 on page
for more information about RIP.
for more information about OSPF.
ZyWALL USG 2000 User's Guide
198.