ZyXEL Communications ZYWALL USG 2000 Manual page 127

Click Network > Routing > Policy Route. You want this policy route to have
1
higher priority than the default policy route for the trunk, so click the Add icon at
the top of the column, not the one next to the existing policy route.
Figure 66 Network > Routing > Policy Route
Configure the policy route as shown next. This policy route applies to traffic from
2
the LAN subnet. Use the VPN connection's local and remote objects as the source
address and destination address objects here. The next-hop is the VPN connection
that you created. Click OK.
Figure 67 Network > Routing > Policy Route > Add
Now set up the VPN settings on the peer IPSec router and try to establish the VPN
3
tunnel. To trigger the VPN, either try to connect to a device on the peer IPSec
router's LAN or click VPN > IPSec VPN > VPN Connection and use the VPN
connection screen's Connect icon.
ZyWALL USG 2000 User's Guide
Chapter 6 Tutorials
127