ZyXEL Communications ZYWALL USG 2000 Manual page 227

In this example, you are creating a new bridge. If you are editing a bridge, the
Interface Name field is read-only. Each field is described in the table below.
Table 64 Network > Interface > Bridge > Edit
LABEL
General Settings
Enable
Interface
Interface
Properties
Interface
Name
Description
Member
Configuration
Available
Member
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
ZyWALL USG 2000 User's Guide
DESCRIPTION
Select this to enable this interface. Clear this to disable this interface.
This field is read-only if you are editing the interface. Enter the name
of the bridge interface. The format is brx, where x is 0 - 11. For
example, br0, br3, and so on.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
This field displays Ethernet interfaces and VLAN interfaces that can
become part of the bridge interface. An interface is not available in
the following situations:
• There is a virtual interface on top of it
• It is already used in a different bridge interface
Select one, and click the >> arrow to add it to the bridge interface.
Each bridge interface can only have one VLAN interface.
This field displays the interfaces that are part of the bridge interface.
Select one, and click the << arrow to remove it from the bridge
interface.
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address, subnet mask, and gateway
automatically.
Select this if you want to specify the IP address, subnet mask, and
gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL sends packets to
the gateway when it does not know how to route the packet to its
destination. The gateway should be on the same network as the
interface.
Chapter 10 Interface
characters, and it can be
227