Table of Contents
Advertisement
Chapter 8. Detailed Editing for Patches
Adjusting the Amount of Resonance (Resonance)
On an acoustic piano, pressing the damper pedal will allow the strings of notes other than the keys you played to resonate sympathetically, creating
a rich and spacious resonance. This parameter adjusts the degree of resonance.
1.
From the PIANO MODE (AC.PIANO) screen, use [
2.
Use the VALUE dial or [DEC] [INC] to adjust the amount of resonance.
Parameter
Resonance
Selecting an Effect for the Electric Piano (EFFECT)
Here you can select effects that are frequently used with an electric piano. The parameters that can be edited will depend on the effect you've selected.
1.
In the PIANO MODE (EL.PIANO) screen, use the cursor buttons to
move the cursor to the effect name (below "EFFECT").
2.
Use the VALUE dial or [DEC] [INC] to change the effect.
Effect name/
Parameter
THRU: No effect will be applied.
Tremolo: Cyclically modulates the volume. The sound will appear to waver.
Wave
Rate
Depth
Chorus: Adds a three-dimensional spaciousness and depth to the sound.
Rate
Depth
Balance
Phaser: Adds a twisting character to the sound.
Manual
Rate
Depth
Resonance
EQ: Adjusts the tone of the high, mid, and low frequency ranges.
Low Gain
Mid1 Gain
Mid2 Gain
High Gain
Speaker: This simulates various speaker types as well as the settings for the microphone used to capture the sound from the speakers.
Speaker
Mic Level
Direct Level
These effect settings are only for Piano mode. The effect you've specified in Piano mode will be applied regardless of the effect settings of the
patch you've selected.
118
] [
Value
Explanation
0–127
Increasing this value will increase the amount of resonance.
Value
TRI, SQR, SIN, SAW1, SAW2
0.05–10.00
0–127
0.05–10.00
0–127
D100:0W–D0:100W
0–127
0.05–10.00
0–127
0–127
-15 [dB]–+15 [dB]
-15 [dB]–+15 [dB]
-15 [dB]–+15 [dB]
-15 [dB]–+15 [dB]
SMALL 1, SMALL 2, MIDDLE, JC-120,
BUILT-IN 1, BUILT-IN 2, BUILT-IN 3, BUILT-IN 4, BUILT-IN 5,
BG STACK 1, BG STACK 2,
MS STACK 1, MS STACK 2, METAL STACK,
2-STACK, 3-STACK
0–127
0–127
] to move the cursor to "Resonance."
3.
Use the cursor buttons to select the parameter that you want to
edit.
Use the VALUE dial or [DEC] [INC] to edit the value.
4.
Explanation
Type of modulation
Frequency of modulation
Depth of effect
Frequency of modulation
Depth of modulation
Volume balance between the original sound (D) and
chorus sound (W)
Center frequency at which the sound is modulated
Frequency of modulation
Depth of modulation
Amount of feedback
Amount of boost/cut for the low frequency range
Amount of boost/cut for the mid-1 frequency range
Amount of boost/cut for the mid-2 frequency range
Amount of boost/cut for the high frequency range
Type of speaker
Volume of the mic
Volume of the direct sound
Advertisement
Table of Contents
