Roland Juno-Stage User Manual page 112

Chapter 8. Detailed Editing for Patches
Parameter Value
Tone Env Mode NSUS, SUST
Rx Bender OFF, ON
Rx Expression OFF, ON
Rx Hold-1 OFF, ON
Rx Pan Mode CONT, K-ON
Redamper Sw OFF, ON
112
Explanation
When a loop waveform (p. 97) is selected, the sound will normally continue as long as the key is
pressed. If you want the sound to decay naturally even if the key remains pressed, set this to
"NSUS."
* If a one-shot type wave (p. 97) is selected, it will not sustain even if this parameter is set to
"SUST."
For each tone, specify whether MIDI Pitch Bend messages will be received (ON), or not (OFF).
For each tone, specify whether MIDI Expression messages will be received (ON), or not (OFF).
For each tone, specify whether MIDI Hold-1 messages will be received (ON), or not (OFF).
* If "NSUS" is selected for Tone Env Mode parameter, this setting will have no effect.
For each tone, specify how pan messages will be received.
CONT: Whenever Pan messages are received, the stereo position of the tone will be changed.
K-ON: The pan of the tone will be changed only when the next note is played. If a pan message
is received while a note is sounding, the panning will not change until the next key is pressed.
* The channels cannot be set so as not to receive Pan messages.
You can specify, on an individual tone basis, whether or not the sound will be held when a Hold
1 message is received after a key is released, but before the sound has decayed to silence.
If you want to sustain the sound, set this "ON." This function is effective for piano sounds.
* In order to use this function, you must also set Rx Hold-1 to "ON."