Setting Effects For A Patch (Effects/Mfx/Mfx Control/Chorus/Reverb) - Roland Juno-Stage User Manual

STEP LFO
Parameter Value
Step Type
TYP1, TYP2
Step Type
ZOOM
Step 1–16
-36–+36
Step 1–16
ZOOM
OUTPUT
Parameter Value
MFX,
L+R,
Patch Out Assign
L, R,
TONE
MFX,
Tone Out Assign L+R,
L, R
Tone Out Level 0–127
Send Level (Output = MFX)
Tone Chorus Send 0–127
Tone Reverb Send
0–127
Send Level (Output = non MFX)
Tone Chorus Send 0–127
Tone Reverb Send 0–127

Setting Effects for a Patch (Effects/MFX/MFX Control/Chorus/Reverb)

For details regarding effect settings, refer to the pages shown below.
• "Making Effect Settings" (p. 79)
• "Multi-Effect Settings (MFX 1–3)" (p. 84)
• "Chorus Settings (CHORUS)" (p. 86)
• "Reverb Settings (REVERB)" (p. 86)
Explanation
When generating an LFO waveform from the data specified in LFO Step 1–16, specify whether the level
will change abruptly at each step or will be connected linearly.
TYP1: stair-step change
TYP2: linear change
Specifies the data for the Step LFO.
If the LFO Pitch Depth is +63, each +1 unit of the step data corresponds to a pitch of +50 cents.
Explanation
Specifies how the direct sound of each patch will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the sound that passes
through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
L: Output in mono to the OUTPUT L jack without passing through the multi-effect
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
TONE: Outputs according to the settings for each tone.
Specifies how the direct sound of each tone will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the sound that passes
through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
L: Output in mono to the OUTPUT L jack without passing through the multi-effect
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
* If the Patch Out Assign is set to anything other than "TONE," these settings will be ignored.
* If "Struct 1 & 2, 3 & 4" (p. 99) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings
of tone 2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs
of tones 3 and 4 are combined into tone 4.)
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through the chorus is set with the Chorus Output Select.
Level of the signal that is sent to the output destination specified by Tone Output Assign
Level of the signal sent to chorus for each tone if the tone is sent through MFX
Level of the signal sent to reverb for each tone if the tone is sent through MFX
Level of the signal sent to chorus for each tone if the tone is not sent through MFX
Level of the signal sent to reverb for each tone if the tone is not sent through MFX
Chapter 8. Detailed Editing for Patches
Parameters indicated by (
ZOOM
) can be edited via ZOOM EDIT (p. 97).
115