Table of Contents
Advertisement
Part 2
Setup Mode
Setting the Type
The
box allows adjustment of the cable loss measurement
Buildout
between the last T1 signal regenerator and your location. This
measurement is supplied by the telephone company at installation. You
need to adjust your buildout based on this measurement.There are four
choices:
•
odb
•
7.5db
•
15db
•
20.5db
Using Push Buttons
This window uses
Apply
detailed information about push buttons, see Chapter 5.
Setting the Switch Type
To set a switch type
1.
Select a single ISDN Primary Rate Annex in the main window.
2.
Display the
T1/PRI Line
3.
Select the
5ESS
will be selected if the switch type has not been set.
Default
displays as selected when the ISDN Primary Rate Annex, operating
outside the United States, has the switch type set to
.
AUS
4.
Press
Apply
Annex Manager sets the switch type.
Chapter 8
Setting ISDN Primary Rate Annex Values
,
,
Restore
Help
window.
,
,
or
NI-2
DMS100
Default
.
Annex Manager User Guide
buttons. For
, and
Close
button.
Other
or
ETS
ETS-
8-15
Advertisement
Table of Contents
