Understanding The Lat Window - Bay Networks Manager User Manual

Part 3 Customize Mode Chapter 11

Understanding the LAT Window

The window uses the following fields:
LAT
• identifies the Annex in the LAT protocol. The
Server Name
name you enter should match the VMS host's node name used
in the HIC configuration file. The default value is
by the server's physical ethernet address (e.g.,
LAT_080002BF0020
•
Remote Group Codes
that can access local services offered by an Annex. To access
these services, the Annex must have at least one enabled group
code that matches the service's group codes. You can enter
, a series of numbers separated by commas, (e.g., 1, 5, 7) or
none
a range of numbers separated by dashes (e.g. 1, 5, 200-255).
You can use any number between 0 and 255.
•
Virtual CLI Group Codes
assigned to virtual CLI users. All virtual CLI users have the
same group code. You can enter
disable all groups, a series of numbers separated by commas
(e.g., 1, 5, 7), or a range of numbers separated by dashes (e.g. 1,
5, 200-255). You can use any number between 0 and 255.
Using the AppleTalk, IP, IPX, and LAT Windows
).
specifies LAT protocol remote group codes
specifies remote group codes that are
to enable all groups,
all
Annex Manager User Guide
followed
LAT
,
all
to
none
11-9