Multiple Writes Of Setting Data - Omron E5ZN Operation Manual

Commands and Responses
5-9-6

Multiple Writes of Setting Data

Command
Response
Variable
MRC SRC
type Address
"01" "13"
Variable
type
Variable Address
type
"C1" "0000" to "0019"
"0100" to "0119"
"C3" "0000" to "003E"
"0100" to "013E"
"C5" "0000"
"0100"
"C7" "0000" to "0001"
"0100" to "0101"
Multiple setting data can be written with the execution of one command. Up to
3 values can be written, even if the addresses are not consecutive.
Refer to 5-10 Variable Area Map for information on specifying variable types
and addresses.
Setting area 1 setting data can be written in setting area 1 only. An error will
be returned if this command is executed for setting area 0.
Before executing the command, use an operation command to enable com-
munications writing.
To save the operation/adjustment level setting data to internal non-volatile
memory, use the "write mode" operation command to set the write mode to
"backup." If it is not set to backup mode, the setting data will not be stored
when the power is turned OFF. Refer to 6-3 Setup Level Configuration and
Front Panel Keys for details on the operation/adjustment level.
MRC SRC Response code
"01" "13" "0000"
Response code: The code shown above represents normal completion. For
details on the response code, refer to 5-6 Write to Variable Area .
Bit
Data
position
"00" Setting data
Bit
position
Address
"00"
Setting data
ch
1 Setting data for setting area 0
2
1 Setting data for setting area 1
2
1 Setting data for setting area 0
2
1 Setting data for setting area 1
2
Section 5-9
Data
Setting data
Description
79