Multi-Sp (Sp 0 To 1) (M-Sp); Ramp Sp Value Monitor (Sp-M); Heater Current Value Monitor (Ct) - Omron E5ZN Operation Manual

Operation Level
7-3-3

Multi-SP (SP 0 to 1) (m-sp)

Function
Communications
See Also
7-3-4

Ramp SP Value Monitor (sp-m)

Function
Communications
Monitoring
See Also
7-3-5

Heater Current Value Monitor (ct)

Function
Communications
130
Condition: The "multi-SP uses" parameter must be set to ON.
Multi-SP allows you to set up to two SPs (SP0 to 1) in the adjustment level.
These can be switched between by operating the keys on the front panel or by
external input signals (event input allocation).
In the parameter, enter SPs 0 to 1. Default is 0.
Use the multi-SP operation commands. Refer to page 81 for information.
• If multi-SP cannot be selected using the event input, set the "No. of multi-
SP uses" parameter to 0 and the "multi-SP uses" parameter to ON. This
will enable SP selection.
• SP can be selected using the communications function also.
Condition: The "SP ramp set value" parameter must not be set to 0.
This parameter monitors the SP while the ramp function is being used.
The ramp function restricts the rate of change in the width of the SP.
The set value is displayed when "SP ramp set value" parameter is set.
When the SP is out of the preset ramp, the SP is matched to the SP set in the
"PV/SP" parameter.
ch
1 C0
2 C0
SP: SP lower limit to SP upper limit
• Related Parameters
"PV/SP" (operation level) (page 129)
"SP ramp set value" (advanced function setting level) (page 155)
"SP upper limit" "SP lower limit" (initial setting level) (page 145)
Condition: Pulse output models only, and the "HBA used" parameter
must be set to "ON."
This parameter measures the heater current value from the CT input used for
detecting heater burnout.
Measures and displays the heater current value.
ch
1 C0
2 C0
Variable type
0002
0102
Monitoring range
Variable type
0003
0103
Section 7-3
Address
Unit
EU
Address