5-10 Variable Area Map - Omron E5ZN Operation Manual

Variable Area Map

5-10 Variable Area Map

Variable Address
type
C0 0000 1
0001
0002
0003
0004
0005
0006
0100 2
0101
0102
0103
0104
0105
0106
90
The variable area of the Temperature Controller is mapped in terms of vari-
able types and addresses as described below.
Variable type C0:
Variable type C1:
Variable type C3:
Variable type C5:
Variable type C7:
Allocations for each variable are listed below.
A dash (-) in the "ch" column indicates data that is used by both channels.
Note
1. This data is used by pulse output models only.
2. This data is used by analog output models only.
3. This data is used by upgraded pulse output models and analog output models only.
ch Monitor value
PV
Status
Internal SP
Heater current value
monitor
MV monitor for heating Standard: FFFFFFCEH to 0000041AH ( 5.0 to 105.0)
MV monitor for cooling 00000000H to 0000041AH (0.0 to 105.0)
PV hold value
PV
Status
Internal SP
Heater current value
monitor
MV monitor for heating Standard: FFFFFFCEH to 0000041AH (-5.0 to 105.0)
MV monitor for cooling 00000000H to 0000041AH (0.0 to 105.0)
PV hold value
Read-only data for setting area 0, including PVs and sta-
tus
Setting data for setting area 0
Setting data for setting area 1
Setting data for setting area 0
Setting data for setting area 1
Temperature: According to specified range for each sensor.
Analog:
Scaling lower limit 5% FS to scaling upper limit + 5% FS
Refer to page 91.
Lower limit of SP to upper limit of SP
00000000H to 00000226H (0.0 to 55.0) (See note 1.)
Heating/cooling: 00000000H to 0000041AH (0.0 to 105.0)
Temperature: According to specified range for each sensor
Analog:
Scaling lower limit 5% FS to scaling upper limit + 5% FS
Value stored in internal non-volatile memory (RAM) when the
"PV hold" operation command was executed.
Temperature: According to specified range for each sensor
Analog:
Scaling lower limit 5% FS to scaling upper limit 5% + FS
Refer to page 91.
Lower limit of SP to upper limit of SP
00000000H to 00000226H (0.0 to 55.0) (See note 1.)
Heating/cooling: 00000000H to 0000041AH (0.0 to 105.0)
Temperature: According to specified range for each sensor
Analog:
Scaling lower limit 5% FS to scaling upper limit + 5% FS
Value stored in internal non-volatile memory (RAM) when the
"PV hold" operation command was executed.
Section 5-10
Description