Display; Setting Switches - Omron E5ZN Operation Manual

Name and Function of Parts
1-1-3

Display

Operation Display
1,2,3...
1-1-4

Setting Switches

Unit Number
Baud Rate
1. POWER
Lit when power is ON.
2. ERROR
Flashes when a memory error or an input error to either channel has oc-
curred.
3. SD/RD (send data/receive data)
Flashes during communications with the host computer.
4. OUT1, OUT2 (control output 1, control output 2)
Lit when control output 1 or 2 is ON.
5. SUB1, SUB2 (auxiliary output 1, auxiliary output 2)
Lit when auxiliary outputs 1 or 2 is ON.
Note There is no display on the front panel for SUB3 and SUB4 (auxiliary output 3 and aux-
iliary output 4) of analog output models.
Use the switches to change the communications conditions for communica-
tions with the host computer. Before using the E5ZN, match the settings to the
host.
Operate the switches under the following conditions only.
• The power supply must be turned OFF. The settings will be enabled only
when the power is turned ON again.
• To change the switch setting, use a flat-blade screwdriver and turn the
switch to the required position.
A unit number is set for each Temperature Controller to identify the Tempera-
ture Controllers connected to the host and to an E5ZN-SDL Setting Display
Unit.
The unit number is set in hexadecimal.
The switch settings are 0 to F, which correspond to unit numbers 00 to 15.
Setting 0 1
Unit No. 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15
↑ Default
Set a different unit number for each Temperature Controller when more than
one E5ZN Temperature Controller is connected for RS-485 communications.
Communications cannot be performed if the same unit number is used more
than once in one system.
Match the E5ZN Temperature Controller baud rate to the host baud rate.
Setting 0
Baud rate 4800
(bit/s)
2 3 4 5 6 7
1 2 3 4
9600 19200 38400
↑ Default
Section 1-1
8 9 A B C D
5 6 7 8
Do not use these settings.
E F
9
3