Hba Used (Hbu); Heater Burnout Latch (Hbl); Heater Burnout Hysteresis (Hbh) - Omron E5ZN Operation Manual

Advanced Function Setting Level
7-6-9

HBA Used (hbu)

Function
Communications
Settings

7-6-10 Heater Burnout Latch (hbl)

Function
Communications
Settings
See Also

7-6-11 Heater Burnout Hysteresis (hbh)

Function
Condition: Pulse output models only
• This parameter sets use of the heater burnout alarm.
• Setting changes to "HBA used" must be enabled by executing a software
reset or by turning ON the power again.
ch
Shared C3
Setting range
00000000H to 00000001H
(off)
0: Not used
(on)
1: Used
Condition: Pulse output models only, and the "HBA used" parameter
must be set to "ON."
• When this parameter is set to ON, the heater burnout alarm is held until
either of the following conditions is satisfied:
a) Heater burnout detection is set to 0.0 A.
b) The power is turned OFF and then turned ON again (power is re-
set).
• When switching to setting area 1, the output is turned OFF.
• Setting changes to "heater burnout latch" must be enabled by executing a
software reset or by turning ON the power again.
ch
Shared C3
Setting range
00000000H to 00000001H
0: Disabled (off)
1: Enabled (on)
• Related Parameter
"HBA used" (advanced function setting level) (page 159)
Condition: Pulse output models only, and the "heater burnout latch"
parameter must be set to "OFF."
• This parameter sets the hysteresis when HBA is detected.
• Setting changes to "heater burnout hysteresis" must be enabled by exe-
cuting a software reset or by turning ON the power again.
Variable type
0022 or 0122
Variable type
0023 or 0123
Section 7-6
Address
Unit Default
- 1: Used
Address
Unit Default
- 0: Disabled
159