Multi-Sp; 5-9-10 At Execute/Stop - Omron E5ZN Operation Manual

Commands and Responses
5-9-9

Multi-SP

Command
Response

5-9-10 AT Execute/Stop

Command
Command
MRC SRC
code
"30" "05" "02"
Related
information
ch
"00" 1
"01"
"10" 2
"11"
"F0" 1, 2
"F1"
This command switches between SPs that have been set in advance for SP 0
and SP1.
"No. of multi-SP uses" must be set to 0 and "Use multi-SP" must be set to ON.
This command can be used for either setting area 0 or 1.
Note These variations of the command are supported by upgraded pulse output models and
analog output models only.
MRC SRC Response code
"30" "05"
Response code: The code shown above represents normal completion. For
details on the response code, refer to 5-7 Operation Commands .
Command
MRC SRC
code
"30" "05" "03"
Related
information
ch
"00" 1
"01"
"10" 2
"11"
"F0" 1, 2
"F1"
This command executes or stopped autotuning.
This command can be used in setting area 0 only. If it is used in setting area
1, an operation error will be returned. An operation error will also be returned
in the following cases.
• When the "RUN/STOP" parameter for the specified channel is set to
"STOP."
• When ON/OFF control is being used.
Before executing the command, use an operation command to enable com-
munications writing.
Note These variations of the command are supported by upgraded pulse output models and
analog output models only.
Related
information
Contents
Selected SP
SP 0
SP 1
SP 0
SP 1
SP 0 (See note.)
SP 1 (See note.)
"0000"
Related
information
Contents
Instruction details
Stop
Execute
Stop
Execute
Stop (See note.)
Execute (See note.)
Section 5-9
81