Copying Parameters From Master To Slaves - Omron E5ZN Operation Manual

Using Copy Mode
6-5-2

Copying Parameters from Master to Slaves

System Configuration
1,2,3...
UNIT
CH
COPY
UNIT
CH
COPY
lowing circumstances. "Down" will not be displayed when download is not
possible.
• When a E5ZN has been added or deleted since the upload.
• When the same number of units are connected as when the upload
was executed, but when the unit numbers are different.
• When the platinum resistance thermometer/thermocouple type config-
uration is different.
This section describes how to copy parameters from a Master to Slaves, as
shown in the following diagram, in which unit number 1 is the Master, and unit
numbers 2 and 3 are the Slaves.
UNIT
COPY CH
E5ZN-SDL
Data uploaded to the E5ZN-SDL can be downloaded only to a Unit whose unit
number has been uploaded. Therefore, after copying the Master parameters,
change the unit number of the Unit where the data is to be downloaded to the
uploaded unit number (Master's unit number), and then download the param-
eter data.
1. Press the COPY Key for at least one second to move to copy mode.
2. Press the UNIT Key to select the unit number of the Master.
In this example, the Master is unit number 1, so select "1."
E5ZN E5ZN E5ZN
1 2 3
Master
Section 6-5
119