Part Names And Functions; Cp1H Cpu Units - Omron CP1H-CPU - 05-2006 Operation Manual

Part Names and Functions

2-1

Part Names and Functions

2-1-1

CP1H CPU Units

(13) Input indicators
(1) Battery cover
(2) Operation indicators
(3) Peripheral USB port
(4) 7-segment display
(5) Analog adjuster
(6) External analog settings
input connector
(7) DIP switch
(8) Built-in analog I/O terminal
block and terminal block
base (See note 1.)
(9) Built-in analog input switch
(See note 1.)
42
Front
(11) Power supply, ground,
and input terminal block
IN
L1 L2/N COM 01 03 05 07 09
00 02 04 06 08
POWER
ERR/ALM
BKUP
ON
00 01 02 03
COM COM COM COM
100CH
OUT
(16) External 24-VDC
(10) Memory
(See note 2.)
Cassette slot
and output terminal
block
Note 1: XA CPU Units only.
Note 2: CPU Units with AC Power Supply only.
(1) Battery Cover
Covers the location where the battery is stored.
(2) Operation Indicators
Show CP1H operation status.
POWER RUN
ERR/ALM INH
BKUP PRPHL
POWER Lit
(Green)
Not lit
RUN Lit
(Green)
Not lit
ERR/ALM Lit
(Red)
Flashing
Not lit
INH Lit
(Yellow)
Not lit
(12) Option Board slots
11 01 03 05 07 09 11
10 00 02 04 06 08 10
EXP
04 06 00 01 03 04 06
05 07 COM 02 COM 05 07
101CH
1CH
(14) Expansion I/O
Unit connector
(15) Output indicators
Power is ON.
Power is OFF.
The CP1H is executing a program in either RUN or
MONITOR mode.
Operation is stopped in PROGRAM mode or due to
a fatal error.
A fatal error (including FALS execution) or a hard-
ware error (WDT error) has occurred. CP1H opera-
tion will stop and all outputs will be turned OFF.
A non-fatal error has occurred (including FAL execu-
tion). CP1H operation will continue.
Operation is normal.
The Output OFF Bit (A500.15) has turned ON. All
outputs will be turned OFF.
Operation is normal.
Section 2-1
Back
(17) Connector for CJ Unit
Adapter