Honda VFR800F 2014 Service Manual page 66

MAINTENANCE
Throttle grip freeplay
can be adjusted
at
either end of
the
throttle cable.
Minor adjustment is made with the
upper adjuster
of
the
throttle
grip
side.
Loosen
the lock nut [1] and turn the adjuster [2]
as
required.
Tighten
the lock nut
while holding
the adjuster.
Major adjustment is made with
the
lower adjuster on the
throitle
bodY.
Lift
the
fuel
tank and support it (page
3-4).
Remove
the socket bolt
[1]
and the throttle drum cover
[2] by releasing the
tab
[3]
from the
throttle
body plate'
Loosen
the lock nut [4] and turn the adjuster [5]
as
required.
Tighten
the lock nut
while holding
the
adjuster.
After
adjustment, recheck the throttle operaiion'
lnstall the throttle drum cover by setting the tab onto the
plate edge and tighten the
socket bolt'
TORQUE:
3.4
N'm (0.3
kgf'm,2.5lbf'fQ
lnstall the fuel
tank (Page 3-4).
AIR CLEANER
NOTE:
.
The viscous paper element type
air
cleaner
cannot
be cleaned because
the element contains
a
dust
adhesive.
.
lf the
motorcycle
is
used
in unusually
wet or
dusty
areas, more
frequent
inspections are required.
Lift
the fuel tank and
support
it (page 3-4).
Disconnect
the vacuum hose
[1]
from the intake duct
valve diaphragm.
Remove the following:
- seven tapping screws
[2]
-
air cleaner cover
[3]
-
air cleaner
element
[4]
Replace
the air cleaner
element in accordance
with the
maintenance
schedule (page 3-3)
or
any time
it
is
excessively dirty or damaged.
Clean
the
inside of the air cleaner cover
and housing.
Make sure
ihe rubber seals
in the cover and housing
are
in position and
in good condition.
lnstallation is
in
the
reverse order
of
removal.
3-5