Honda VFR800F 2014 Service Manual page 198

CYLINDER HEAD/VALVES
WHEN
BOTH THE
FRONT AND
REAR GAMSHAFTS
WERE
REMOVED:
Turn the crankshaft clockwise and align the "3T"
mark
on the CKP sensor
rotor with the index mark
[1] on the
right crankcase
cover (No. 3 piston
is at TDC).
lnstall
the camshaft
holder B with the
boss
facing the cam
sprocket.
Apply
molybdenum
oil
solution
to
the cam
lobes.
journals,
and thrust surface.
lnstall the rear
cylinder
intake
[1] and
exhaust
[2]
camshafts while installing cam chain [3] over
the
cam
sprockets.
Position
the
index lines
[4]
("R1" for
jntake/,'RE,' for
exhaust)
on the cam sprocket
facing outward and
align
them with the cylinder
head
surJace.
Install
the
joint collars
['1]
onto
the
rear cylinder
head.
Coat
new O-rings
[2]
with engine oil
and
install them.
lnstall the camshaft holder
A
[1] onto the rear
cylinder
head with the
"lN'
mark facing the
intake
side,
lnstall the "Rl"
marked camshaft holder B
[2] onto
the
intake camshaft and the "RE" marked camshaft
holder
B [3] onto the exhaust camshaft.
10-14