Honda VFR800F 2014 Service Manual page 354

ABS (ll AC, lll
CM
types)
MGS INFORMATION
.
The MCS can read out and erase the
DTC.
How to connect the
MCS
Remove the front seat (page 2-3)
Turn the ignition switch
OFF.
Release the
DLC
[1]
from the stay and remove the
dummy connector
[2].
Connect
the
MCS to the
DLC.
Turn the ignition switch ON with the engine stop switch
",3"
and
check the
DTC.
DTC READOUT
NOTE:
'
The DTC is
not
erased
by
turning the ignition switch OFF while the
DTC is being output. Note that turning the
ignition swltch
ON
again does not indicate the
DTC. To show
the
DTC again, repeat the DTC readout procedures from
the beginning.
.
Be sure
to
record the indicated DTC(s).
'
After
diagnostic troubleshooting, erase the
DTC and
perform the pre-start self-diagnosis
procedure
to be sure that there is
no
problem
in the
ABS (page
18-5).
.
Do not apply
the
brake during DTC readout.
Connect the MCS to the DLC
(page
18-6)
Read the DTC and follow the
DTC index
(page
18-9)
.
lf
the
MCS is not available, per-form
the following.
Reading
DTC
with
the
ABS indicator
Remove the front seat (page
2-3).
Turn the ignition switch
OFF,
Release
the DLC [1]from the
stay and remove the dummy connector
[2].
Short the DLC terminals
using the special
tool.
TOOL:
[3]
SCS
service
connector
070P2-2Y30100
CONNECTION: Brown
-
Green
Turn the
ignition switch ON with
the
engine stop switch to
"O",
The ABS
indicator should come on for 2 seconds (start signal) (then goes
off 3.6 seconds) and start
DTC indication.
The DTC is indicated
by
the number of the times
of the
ABS
indicator
blinks.
lf the DTC is not stored, the ABS
indicator stays
on.
18-6