Honda VFR800F 2014 Service Manual page 356

ABS (ll AC, lll
CM
types)
CIRCUIT !NSPECTION
INSPEGTION AT ABS MODULATOR
CONNECTOR
Remove the
left middle cowl (page 2-6).
Turn
the
ignition switch OFF.
Disconnecting procedure:
Turn the
lock lever
[1]
while pressing
the lock tab
[2]
to release
it.
Be sure the lock lever is
turned
all the way and
disconnect
the
ABS
modulator 18P (Black) connector
[3].
Connecting procedure:
Be sure to fully seat the lock lever against the wire side of the
connector.
Connect the ABS modulator 18P (Black) connector by pressing
it straight at
the area as
shown (arrow) until the
lock tab clicks.
Make sure the connector is locked securely.
.
Always clean around
and keep any foreign material away from
the
connector before disconnecting
it.
. A
faulty ABS
is
often related
to
poorly connected
or
corroded
connections. Check those connections before proceeding.
.
ln
testing
at
ABS modulator 18P (Black) connector terminals
(wire
harness side; except No. 9 and No.
18
terminals), always use the test
probe
[1].
lnsert the
test probe
into the connector terminal, then
connect
the
digital multimeter probe to the
test
probe.
TOOL:
Test probe
(2
Pack)
07ZAJ-RDJAI10
TERMINAL
LAYOUT:
f;l
ErrlcTtETr,,
t;
-i__--'--;
!L
hnqcf,a,a,illIL
(Terminal side
of the wire harness)
18-8