Honda VFR800F 2014 Service Manual page 322

REAR WHEEL/SUSPENSION
lnstall the caliper stay
[1]
onto the
bearing holder sleeve
and swingarm boss while adjusting
the
bearing
holder
position.
Install the snap ring
[2] with the
chamfered edge facing
the stay
Make sure the snap ring
is fully seated
in
the groove.
Move the caliper stay forward fully (drive chain
fully
slacked position) by turning
the
bearing holder.
lnstall
the rear axle/disc
assembly
[1].
lnstall the
brake
caliper
[2]
with new mounting bolts
[3]
and tighten them to the specified torque,
TORQUE:
33 N.m (3.4
kgf.m,
24tbf
.ft)
Wipe
the tip of
rear wheel speed sensor
[4]
and
mounting area to
remove any foreign
material.
lnstall the wheel speed sensor and tighten the two bolts
I5l
lnstall
the
driven flange assembly [1] and the
drive
chain [2] over the
driven sprocket.
16-g