Honda VFR800F 2014 Service Manual page 136

FUEL SYSTEM
FUEL LINE INSPEGTION
FUEL PRESSURE RELIEVING
Do not
pull
on the
retainer.
NOTE:
.
Before
disconnecting
fuel feed
hose,
relieve
pressure from the system as
follows.
1.
Turn the ignition switch OFF.
2.
Lift
the fuel tank and
suppotl it (page 3-4).
3.
Disconnect the
fuel
pump 3P (Black) connector
[1].
4.
Stari the engine
and let it idle until the engine stalls.
5.
Turn the ignition switch OFF.
QUICK CONNECT FITTING REMOVAL
NOTE:
.
Clean around
the quick connect fitting
before
disconnecting the
fuel feed hose,
and be
sure that
no
dirt
is allowed
to enter into the
fuel
system.
.
Do not bend or twist the fuel
feed hose.
.
lf
the fuel feed hose is
to be replaced, the air cleaner
housing removal/installation is required (page
7
-12).
1.
Relive the
fuel
pressure (page 7-5).
2.
Disconnect
the negative
(-)
cable from
the
battery
(page 19-6).
3.
Place a shop
towel over the
quick
connect fitting.
4.
Pull
the reiainer
['1]
up
fully to release the lock.
5.
Pull the connector [2] and disconnect
it.
NOTE:
.
Be careful not
to
damage
the
connector parts.
Do
not use tools.
.
Use
a
shop towel
to prevent the remaining
fuel
in
the
fuel
feed hose from flowing
out.
.
lf the connector
does not move, alternately pull
and
push the connector until
it
comes off easily.
6. To prevent damage and keep foreign matter
out,
cover the disconnected connector
and
joint
pipe with
plastic bags.
7-5