Honda VFR800F 2014 Service Manual page 176

LUBRICATION SYSTEM
SERVICE INFORMATION
GENERAL
This section covers service
of
the
oil pump and oil cooler.
The oil pump
can
be serviced with the engine installed
in
the frame.
The service procedures
in this section must be performed with the engine oil drained.
When removing
and
installing the oil pump, use care not to allow
dusior
dirt to enter the engine.
The oil pump has
twin pump rotors; feed and cooler. The
feed pump rotors draw
oil
frori
the oil
cooler and crankcase
and
delivers it under pressure to
the
bearings and other important parts bt the engine. The cooler pump rotors draw oil from
the
crankcase and sends
it
to the oil cooler.
After the oil pump has
been
installed, check that
there
are no oil leaks and that
oil
pressure is correct.
For engine
oil
pressure
indicator/EOp
switch inspection
(page
20_17).
TOOLS
Used engine oil may cause skin cancer
if repeatedly left
in
contact with the skin for prolonged periods. Although
this
is unlikely
::99: Ii13:91",H:d
?1on
a
daily
basis, it is stili advisable to thoroughty wash your hands with soap and water as soon as
possible
after
handling used
oil.
Oil pressure gaugeEtachnrer
pressure gauge set
Gauge
loint
attachrnent
07406-0030000
07506-300000
1
07RMK-MW40100
or equivalent commercially available
in
U.S.A.
or
equivalent commercially available
in
U.S.A.
or
07AMJ-001A100 (U.S.A.
onty)
9-2