Acx1000 And Acx1100 Routers Quick Start Description - Juniper ACX1100 Quick Start Manual

ACX1000 and ACX1100 Routers Quick Start Description

Copyright © 2015, Juniper Networks, Inc.
This Quick Start contains information you need to install and configure the router quickly.
For complete installation instructions, see the
at
Routers Hardware Guide
WARNING: This Quick Start contains a summary of safety warnings in
Warnings" on page
translations, see the
Guide at http://www.juniper.net/techpubs/
The ACX Universal Access Router is principally designed for high-density access and
pre-aggregation and is environmentally hardened. The router can be used as a cell site
router or pre-aggregation device for mobile backhaul and a CPE for business or residential
access.
The routers are single-board routers with a built-in Routing Engine and one Packet
Forwarding Engine. The Packet Forwarding Engine has one "pseudo" Flexible PIC
Concentrator (FPC 0). Because there is no switching fabric, the single Packet Forwarding
Engine takes care of packet forwarding.
The ACX Series router is powered by Junos OS, supporting extensive L2 and L3 features,
IP/MPLS with traffic engineering, rich network management, fault management, service
monitoring and Operation, Administration, and Maintenance (OAM) capabilities, and an
open software development kit (SDK) system that allows providers to customize and
integrate operations with their own management systems. For a list of related Junos OS
documentation, see
http://www.juniper.net/techpubs/software/junos/
As part of the mobile backhaul, the ACX Series router at the cell site and the MX Series
router at the aggregation layer provide comprehensive end-to-end Ethernet, MPLS, and
OAM features with the one Junos OS running on both platforms.
The compact routers are one rack unit (U; that is, 1.75 in., or 4.45 cm) tall. Several routers
can be stacked in a single floor-to-ceiling rack for increased port density per unit of floor
space.
The ACX1000 and ACX1100 routers contain twelve Gigabit Ethernet ports, eight of which
are RJ-45 ports. The ports labeled
or four Gigabit Ethernet SFP ports. You can only use one set of combination ports at a
time.
The ACX1000 router also contains eight T1/E1 ports.
Figure 1 on page 4 shows the front panel of the ACX1000 router.
and Figure 3 on page 5 show the front panel of the ACX1100 router.
ACX1000 and ACX1100 Routers Quick Start Description
ACX1000 and ACX1100 Universal Access
http://www.juniper.net/techpubs/
21. For a complete list of warnings for this router, including
ACX1000 and ACX1100 Universal Access Routers Hardware
COMBO PORTS provide an additional four RJ-45 ports
.
.
.
Figure 2 on page 4
"Safety
3