Table of Contents
Advertisement
Figure 10-29 Preferences - Protocols screen
Backup Protocol Database to CD
The Backup function allows you to save the entire protocols database (parameters) to a CD. This is
important when editing protocols; backup ensures that the current database stays intact. Backup is also
important in case of system failure and all protocol information is lost. If necessary, the old database can
be retrieved and used.
Follow this process to back up the database to a CD.
NOTE: Always use a new, blank CD-R for each back up.
DO NOT use re-writable (CD-RW) disks. The system cannot write to this type of disk.
1. Insert a blank CD into the CD tray.
2. From the Worklist screen, press [UTILITIES].
The Utilities screen appears.
3. Select Preferences > Protocols.
4. Press [BACK UP].
A message appears: "Press OK to continue with Protocol Database back up."
Definium 5000 X-Ray System
Operator Manual
5197809-1EN
Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 10: Set Preferences
10-41
Advertisement
Table of Contents
