Add Image Annotations - GE Definium 5000 Operator's Manual

Add Image Annotations

NOTE: All image annotations initially appear in the same place (center of image) and are the same shape,
size, and/or angle. It is possible to have multiple annotations of the same kind stacked on top of
each other.
Follow this process to add image annotations.
1. Select the image to annotate, if necessary.
2. Press the button of the annotation to insert.
NOTE: Selected image annotations are yellow with red handles. Unselected image annotations are aqua
without handles.
3. Move, re-size, or change the angle of the annotation as described in Table 8-5.
NOTE: When resizing annotations, make sure that the pointer arrow is inside the square handle and has
changed to a "+" sign (Figure 8-8) before trying to move the handle.
Figure 8-8 Active annotation handle
Table 8-5 Image annotation instructions
Tool
Line
Ellipse
Definium 5000 X-Ray System
Operator Manual
Select the line.
• To move: Press and drag the middle of the line.
• To change the angle: Press and drag one of the square handles
at the ends of the line.
• To resize: Press and drag one of the square handles at the ends
of the line.
Select the ellipse.
• To move: Press and drag the ellipse by its edge (not on a handle).
• To change shape or re-size: Press and drag a square handle.
5197809-1EN Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 8: Image Viewer
Instructions
8-13