Error Messages - GE LOGIQ 500 Advanced Reference Manual

Data Management Center (DMC)

Error Messages

Message
Check Computer. No power.
Check Computer. Bad condition.
Check Computer. Abnormal response.
Check Computer. Checksum Error occurred.
Check Computer. No response.
Can't send data to Computer in this category.
System doesn't have option.
SYSTEM ERROR: CANNOT COMMUNICATE
WITH COMPUTER.
This function is not available.
Table 4–1. Data Management Center Error Messages
4–32
If an anomaly occurs in the communication or transfer of data
between the LOGIQ
be displayed on the LOGIQ
messages are:
PC power is off. Interface cable broken or discon-
nected.
PC is busy. LOGIQ
accept data.
LOGIQ
the PC.
LOGIQ
ment from the PC after all data has been sent.
LOGIQ
acknowledgement from the computer after all data
has been sent.
User is trying to send data to the PC in an exam
category other than OB, GYN or Vascular.
The OB calculation option for the LOGIQ
been turned off.
A LOGIQ
not allow communication with the computer to begin.
This function is not available in some situations.
500 and the PC, an error message will
500 screen. Possible error
Possible Cause
500 senses the PC cannot
500 senses an abnormal response from
500 senses an abnormal acknowledge-
500 senses no
500 system error has occurred that will
LOGIQ 500 Advanced Reference Manual
500 has
2276614–100 Rev. 0