Table of Contents
Advertisement
Tool Panel Selection
Different tools and controls are accessed through the Tool Selection list. Press the down-arrow to see a
list of all choices.
The following sections describe the tools and their functions.
Figure 8-2 Tool selection list
Select Images to View
The Images - Raw and Images - Processed panels (Figure 8-3) allow you to select images to view. Both
the Raw and Processed panels function the same way. The difference is that the Raw panel shows
images as they were acquired and the Processed panel shows images that have been processed.
NOTE: When viewing or adjusting images from a completed exam, always work with processed images.
The top half of the tool panel shows the different exams and series that are available. When you select a
series, previews (or "thumbnails") of all the images within that series appear in the lower half of the panel.
The panel shows up to 8 image previews at a time. If there are more than 8 images in the series, a
scrollbar appears on the right to allow you to see the rest of the images.
The image that is currently selected in the Image Viewer is shown with an orange border and a white dot
in the upper right corner.
To view an image, press an image preview.
Figure 8-3 Images – Processed panel
Definium 5000 X-Ray System
Operator Manual
5197809-1EN
Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 8: Image Viewer
8-5
Advertisement
Table of Contents
