Installing The Battery - IBM BladeCenter JS22 Problem Determination And Service Manual

Table of Contents

Advertisement

1. Read "Safety" on page v and the "Installation guidelines" on page 237.
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
4. Open and remove the blade server cover. See "Removing the blade server
5. Locate the battery on the system board. See "System-board connectors" on page
6. Use your finger to press down on one side of the battery; then, slide the battery
7. Use your thumb and index finger to pull the battery from under the battery

Installing the battery

You can install the battery.
Figure 25. Installing the battery
The following notes describe information that you must consider when replacing
the battery in the blade server.
v When replacing the battery, you must replace it with a lithium battery of the
v To order replacement batteries, call 1-800-426-7378 within the United States, and
v After you replace the battery:
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
264
JS22 Type 7998: Problem Determination and Service Guide
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 239.
side up.
cover" on page 242.
9 for the location of the battery connector.
out from its socket. The spring mechanism will push the battery out toward
you as you slide it from the socket.
Note: You might need to lift the battery clip slightly with your fingernail to
make it easier to slide the battery.
clip.
Note: After you remove the battery, press gently on the clip to make sure that
the battery clip is touching the base of the battery socket.
same type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
1. Set the time and date.
2. Set the Network IP addresses (for blade servers that start up from a
network).
3. Reconfigure any other blade server settings.

Advertisement

Table of Contents
loading

This manual is also suitable for:

7998

Table of Contents