IBM BladeCenter JS22 Problem Determination And Service Manual page 168

Table 22. 101-711 through FFC-725 SRNs (continued)
SRN FFC
252B-718 252B 293
252B-719 252B
252B-720 252B
252B-721 252B
252B-722 252B
252B-723 252B
254E-201 254E 221
254E-601 254
254E-602 254
254E-603 254
254E-604 254
254E-605 254
254E-606 254
254E-701 254E 221
154
JS22 Type 7998: Problem Determination and Service Guide
Description and Action
Temporary PCI bus error detected by adapter.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Device bus termination power lost or not detected.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Adapter detected device bus failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Temporary adapter detected device bus failure.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Device bus interface problem.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Device bus interface problem.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see "POST progress codes (checkpoints)" on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Adapter configuration error. Go to "Performing the checkout procedure" on page
187.
Error log analysis indicates adapter failure. Go to "Performing the checkout
procedure" on page 187.
Error log analysis indicates an error attention condition. Go to "Performing the
checkout procedure" on page 187.
Error log analysis indicates that the microcode could not be loaded on the adapter.
Go to "Performing the checkout procedure" on page 187.
Error log analysis indicates a permanent adapter failure. Go to "Performing the
checkout procedure" on page 187.
Error log analysis indicates permanent adapter failure is reported on the other port
of this adapter. Go to "Performing the checkout procedure" on page 187.
Error log analysis indicates adapter failure. Go to "Performing the checkout
procedure" on page 187.
Error log analysis indicates permanent adapter failure. Go to "Performing the
checkout procedure" on page 187.