Installing The Battery - IBM BladeCenter HS21 Series Problem Determination And Service Manual

Installing the battery

The following notes describe information that you must consider when you are
replacing the battery in the blade server.
v When you are replacing the battery, you must replace it with a lithium battery of
v To order replacement batteries, call 1-800-426-7378 within the United States, and
v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
2. Insert the battery:
3. Install the Memory and I/O Expansion Blade, if one was removed from the blade
98
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide
the same type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
system date and time.
battery.
a. Hold the battery in a vertical orientation so that the smaller side is facing the
socket.
b. Place the battery into its socket, and press the battery toward the housing
until it snaps into place.
server in order to replace the battery (see "Installing an expansion unit" on page
83).