Table of Contents
Advertisement
Table 13. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
Error code
BA140004
BA150001
BA151001
BA151002
BA153002
BA153003
BA154010
BA154020
Description
The SCSI read/write optical send
diagnostic failed; devofl command.
PCI Ethernet BNC/RJ-45 or PCI
Ethernet AUI/RJ-45 adapter: internal
wrap test failure
10/100 Mbps Ethernet PCI adapter:
internal wrap test failure
10/100 Mbps Ethernet card failure
Gigabit Ethernet adapter failure
Gigabit Ethernet adapter failure
HEA software error
The required open firmware property
was not found.
Action
1. Troubleshoot the SCSI devices.
2. Verify that the SCSI cables and devices are
properly plugged. Correct any problems
that are found.
3. Replace the SCSI cables and devices.
4. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
Replace the adapter specified by the location
code.
Replace the adapter specified by the location
code.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 270.
Verify that the MAC address programmed in
the FLASH/EEPROM is correct.
1. Check for server firmware updates; then,
install the updates if available.
2. Replace the Gigabit Ethernet adapter.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 270.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
Chapter 2. Diagnostics
73
Advertisement
Table of Contents
