Removing A Combination-Form-Factor Expansion Card - IBM BladeCenter JS22 Problem Determination And Service Manual

9. Install and close the blade server cover. See "Installing and closing the blade
server cover" on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
10. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 240.
11. Use the documentation that comes with the expansion card to install device
drivers and to perform any configuration that the expansion card requires.

Removing a combination-form-factor expansion card

Complete this procedure to remove a combination-form-factor expansion card.
Expansion cards
Figure 22. Removing a combination-form-factor expansion card
1. Read "Safety" on page v and the "Installation guidelines" on page 237.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 239.
Chapter 4. Removing and replacing blade server components
261