Removing The Battery - IBM BladeCenter JS22 Problem Determination And Service Manual

1. Read "Safety" on page v and the "Installation guidelines" on page 237.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See "Removing the blade server from
a BladeCenter unit" on page 239.
3. Open and remove the blade server cover. See "Removing the blade server
cover" on page 242.
4. Remove the plastic cover for the PCI-Express connector.
5. Touch the static-protective package that contains the part to any unpainted
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the part from its package.
6. Install the vertical (CFFv) CFFx portion of the expansion card (the smaller
card) by gently pushing the card onto the PCI-X connector.
7. Install the horizontal (CFFh) CFFe portion of the expansion card.
a. Slide the card into the raised hook on the system board.
b. Gently pivot the card into the PCIe connector.
8. Install and close the blade server cover. See "Installing and closing the blade
server cover" on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
9. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 240.
10. Use the documentation that comes with the expansion card to install device
drivers and to perform any configuration that the expansion card requires.

Removing the battery

You can remove and replace the battery.
Figure 24. Removing the battery
Perform the following procedure to remove the battery.
Chapter 4. Removing and replacing blade server components
263