IBM BladeCenter JS22 Problem Determination And Service Manual page 78

Table 13. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
Error code
BA060060
BA060061
BA060070
BA060071
BA060072
BA060075
64
JS22 Type 7998: Problem Determination and Service Guide
Description
The operating system expects an IOSP
partition, but it failed to make the
transition to alpha mode.
The operating system expects a
non-IOSP partition, but it failed to make
the transition to MGC mode.
The operating system does not support
this system's processor(s)
An invalid number of vectors was
received from the operating system
Client-arch-support hcall error
Client-arch-support firmware error
Action
1. Verify that:
v The alpha-mode operating system image
is intended for this partition.
v The configuration of the partition
supports an alpha-mode operating
system.
2. If the problem remains:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
1. Verify that:
v The alpha-mode operating system image
is intended for this partition.
v The configuration of the partition
supports an alpha-mode operating
system.
2. If the problem remains:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
Boot a supported version of the operating
system.
Boot a supported version of the operating
system.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 270.
1. Go to "Checkout procedure" on page 186.
2. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis assembly"
on page 270.