Table of Contents
Advertisement
Table 24. A00-FF0 through A24-xxx SRNs (continued)
SRN
A1D-19x
A1D-20x
A1D-21x
A1D-23x
A1D-24x
A1D-29x
A1D-30x
A1D-31x
178
JS22 Type 7998: Problem Determination and Service Guide
Description
A non-critical error has been detected, a
service processor error accessing real
time clock/time-of-day clock.
A non-critical error has been detected:
Service processor error accessing scan
controller/hardware.
A non-critical error has been detected, a
service processor detected error with
time-of-day clock backup battery.
A non-critical error has been detected:
Loss of heart beat from Service
Processor.
A non-critical error has been detected, a
service processor detected a
surveillance time-out.
A non-critical error has been detected, a
service process error accessing power
control network.
A non-critical error has been detected:
Non-supported hardware.
A non-critical error has been detected:
Error detected while handling an
attention/interrupt from the system
hardware.
FRU/action
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see "POST progress codes
(checkpoints)" on page 88.
2. If no entry is found, replace the system-board
and chassis assembly.
Advertisement
Table of Contents
