Table of Contents
Advertisement
Table 13. BA000010 to BA400002 Partition firmware SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, "Parts listing, Type 7998," on page 235 to determine which components are CRUs and which
components are FRUs.
Error code
BA010005
BA010006
BA010007
BA010008
BA010009
BA01000A
Description
File transmission (TFTP) failed
The boot image is too large
The device does not have the required
device_type property.
The device_type property for this device
is not supported by the iSCSI initiator
configuration specification.
The arguments specified for the ping
function are invalid.
The itname parameter string exceeds the
maximum length allowed.
Action
Perform the following actions that checkpoint
CA00E174 describes:
1. Verify that:
v The bootp server is correctly configured;
then, retry the operation.
v The network connections are correct;
then, retry the operation.
2. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
Start up from another device with a bootable
image.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
1. Reboot the blade server.
2. If the problem persists:
a. Go to "Checkout procedure" on page
186.
b. Replace the system-board and chassis
assembly, as described in "Replacing the
Tier 2 system-board and chassis
assembly" on page 270.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
The embedded host Ethernet adapters (HEAs)
help provide iSCSI, which is supported by
iSCSI software device drivers on either AIX or
Linux. Verify that all of the iSCSI configuration
arguments on the operating system comply
with the configuration for the iSCSI Host Bus
Adapter (HBA), which is the iSCSI initiator.
Chapter 2. Diagnostics
53
Advertisement
Table of Contents
