Table of Contents
Advertisement
9. Install the bezel assembly. See "Installing the bezel assembly" on page 245 for
instructions.
10. Install and close the blade server cover. See "Installing and closing the blade
server cover" on page 243.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
11. Write the machine type, model number, and serial number of the blade server
on the repair identification (RID) tag that comes with the replacement
system-board and chassis assembly. This information is on the identification
label that is behind the control-panel door on the front of the blade server.
Important: Completing the information on the RID tag ensures future
entitlement for service.
12. Place the RID tag on the bottom of the blade server chassis.
13. Install the blade server into the BladeCenter unit. See "Installing the blade
server in a BladeCenter unit" on page 240.
14. Turn on the blade server and press the keyboard/video select button to switch
control of the keyboard and video to the blade server.
Because you are using a management card that was initialized from your old
system board and chassis assembly, the firmware retrieves the VPD from the
management card and caches it in blade server memory and you do not see
any prompts for data.
15. Reset the system date and time through the operating system that you
installed.
For additional information, see the documentation for your operating system.
Chapter 4. Removing and replacing blade server components
271
Advertisement
Table of Contents
