Xerox Phaser 4600 Service Manual page 83

12-300-00, 12-488-00, 12-489-00 Jam in Finisher Exit RAP
12-300-00 Media jam at Finisher exit.
12-488-00 Media did not clear the Finisher exit sensor.
12-489-00 Media did not reach the Finisher exit sensor on time.
BSD-Reference:
WD 17
Initial Actions
• Check the exit sensor and actuator.
• Check for obstructions blocking the media path.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: Remove the Finisher top cover,
REP 12.5 to access the transport motor.
Check the condition of the Finisher feed rollers. The feed rollers are clean and rotate freely.
Y N
Clean or repair the affected feed rollers.
code 12-805 to test the Finisher exit sensor. The
Select dC330
(high/low).
Y N
Remove the Finisher, GP 14 to check the condition of the Finisher option connector, sen-
sor and harness. The sensor is connected and the harness undamaged.
Y N
Replace the sensor or repair the harness.
Replace the Finisher Control Board,
Select dC330 code 12-110 to test the Finisher Transport Motor,
rotates (on/off).
Y N
Check the Transport Motor connection and harness. Repair or reconnect as necessary.
Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged.
Y N
Repair the harness.
Replace these components in order until the error is corrected.
1. IOT Upper Option Harness, PL 10.30 Item 24
2. MCU Board, PL 3.10 Item 3
Revised
Phaser 4600/4620/4622 Printer Service Manual
WARNING
REP 12.18 to access the sensor and actuator. Use
sensor signal
REP 12.2.
8. The
PL 12.40 Item
12-500-00 Full Stack RAP
12-500-00 The Stack Full Sensor indicates the Finisher Stacker Tray is full.
BSD-Reference:
WD 17
Initial Actions
• Check the stacker full sensor actuator.
• Check for obstructions blocking actuator motion.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: Remove the Stacker Shield Assembly,
code 12-770 to test the stacker full sensor. The sensor signal changes (high/
Select dC330
low).
Y N
Remove the Finisher,
sor and harness. The sensor is connected and the harness undamaged.
Y N
Replace the sensor or repair the harness.
Replace the Finisher Control Board,
changes
Select dC330 code 12-885 to test Finisher entrance motor,
rotates (on/off).
Y N
Check the entrance motor connection and harness. Repair or reconnect as necessary.
Check the Finisher option harness in the Finisher Right Cover. The harness is undamaged.
Y N
Repair the harness.
motor
Replace these components in order until the error is corrected.
1. IOT Upper Option Harness,
2. MCU Board, PL 3.10 Item 3
04/2016
2-59
WARNING
REP 12.24 to access the sensor and actuator.
GP 14 to check the condition of the Finisher option connector, sen-
REP 12.2.
PL 12.40 Item
PL 10.30 Item 24
12-300-00, 12-488-00, 12-489-00, 12-500-00
10. The motor
2 Status Indicator RAPS