Xerox Phaser 4600 Service Manual page 72

09-230-00, 09-250-00 Toner Cartridge CRUM Write/Read
Error RAP
09-230-00 Fail to write the information to the Toner Cartridge CRUM.
09-230-00 Fail to read the information from the Toner Cartridge CRUM.
BSD-Reference:
WD 7
Initial Actions
• Cycle system power.
• Replace the Toner Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Toner Cartridge CRUM connection. The connection is clean and undamaged.
Y N
Cycle system power. The error message is displayed.
Y N
Reassemble and perform SCP 6
Replace the Toner Cartridge. The error message is displayed.
Y N
Reassemble and perform SCP 6
28.2) and reseat CN2 on the MCU Board. The
Remove the Right Cover (REP
message is displayed.
Y N
Reassemble and perform SCP 6
Replace the MCU Board, REP 9.8.
28.3) and check the toner CRUM harness. The harness is con-
Remove the Left Cover (REP
nected and undamaged.
Y N
Repair or reconnect the harness.
Replace these components in order until the error is corrected.
1. Joint Board, PL 9.15 Item 7
2. MCU Board, PL 3.10 Item 3
2 Status Indicator RAPS
09-230-00, 09-250-00, 09-240-00
WARNING
Final Actions.
Final Actions.
Final Actions.
09-240-00 Toner Cartridge Communications Error RAP
09-240-00 Fail to communicate with the Toner Cartridge CRUM.
NOTE: Messages are different based on the Toner Fault Count.
BSD-Reference:
WD 7
Initial Actions
• Cycle system power.
• Replace the Toner Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Toner Cartridge CRUM connection. The connection is clean and undamaged.
Y N
Cycle system power. The error message is displayed.
Y N
Reassemble and perform
Replace the Toner Cartridge. The error message is displayed.
Y N
Reassemble and perform
Remove the Right Cover
message is displayed.
error
Y N
Reassemble and perform
Replace the MCU Board,
Remove the Left Cover (REP
nected and undamaged.
Y N
Repair or reconnect the harness.
Replace these components in order until the error is corrected.
1. Joint Board, PL 9.15 Item 7
2. MCU Board, PL 3.10 Item 3
04/2016
2-48
WARNING
SCP 6 Final Actions.
SCP 6 Final Actions.
28.2) and reseat CN2 on the MCU Board. The
(REP
SCP 6 Final Actions.
REP 9.8.
28.3) and check the toner CRUM harness. The harness is con-
Phaser 4600/4620/4622 Printer Service Manual
error
Revised