Xerox Phaser 4600 Service Manual page 36

03-440-00 Tray 5 Paper Mismatch RAP
03-440-00 Media size setting for Tray 5 differ from those reported by the Size Switch.
BSD-Reference:
WD 13
Initial Actions
• Check media size settings for the tray from the Control Panel.
• Reset the tray side and rear guides.
• Check for obstructions blocking the Size Switch.
Procedure
Use safe handling procedures when removing the module. Refer to
is heavy.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Inspect the Tray 5 end guide. The end guide operates the Size Switch actuators.
Y N
Replace the Tray,
codes 07-520, 07-530, 07-540. The switches are operational (high/low).
Select dC330
Y N
Replace the Size Switch, REP 7.30.
Remove the IOT, Tray 3 and Tray 4 from the Feeder. Check the Tray 5 Upper Option Harness.
The harness is undamaged.
Y N
Replace the Upper Option Harness, REP 7.31.
Check option harness continuity through all trays. The harnesses are undamaged.
Y N
Replace damaged harnesses.
Check the IOT Lower Option Harness. The harness is undamaged.
Y N
Replace the Lower Option Harness,
Replace these components in order until the error is corrected.
1. Size Switch, PL 3.10 Item 9
2. Tray, PL 7.10 Item 23
3. Feeder Board, PL 8.30 Item 7
4. MCU Board, PL 3.10 Item 3
2 Status Indicator RAPS
03-440-00, 03-450-00
WARNING
GP 15. The module
WARNING
REP 10.5.
03-450-00 Tray 1 Paper Mismatch RAP
03-450-00 Tray 1 is not configured with the proper media resources for the current job.
BSD-Reference:
WD 5
Initial Actions
• Check media size settings for the tray from the Control Panel.
• Load Tray 1 with the media specified in the print job.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
code 07-110. The sensor is operational (high/low).
Select dC330
Y N
Replace the Tray 1 No Paper Sensor,
Remove the Tray 1 Feeder (REP
and connected to the MCU Board.
Y N
Reconnect or repair the harness.
Replace these components in order until the error is corrected.
1. Tray 1 Feeder, PL 8.10 Item 14
2. MCU Board, PL 3.10 Item 3
04/2016
2-12
WARNING
REP 7.15.
7.0) and inspect the wiring. The harness is undamaged
Phaser 4600/4620/4622 Printer Service Manual
Revised